427 Cobra
Roll Bars Thru Body
Change Order
Chronological Order
Main
Ordering
Receiving
Inventory
Fuel Tank
Brackets
Powder Coating
Engine Build
Frame Dolly
Frame Problems
Fuel Lines
Air Breather
Headers
Aligning The Body
Wheels
Clutch
Brake Lines
Pipes
Radiator
Roll Bars
Rear Axle
Body Mounting
Steering
Dash
Pedals
Engine Stand
Front Suspension
Engine Mount
Transmission Mount
Seats
Emergency Brake
Trunk Hinges
Trunk Latch
Trunk Lid Support
Door Latch
Door Striker
Door Fit
Hood
Hood Support
Rear Bumper
Gas Cap
Roll Bars Thru Body
Convertable Top
Wiring Trunk
Wiring Dash
Wiring
Wipers
Final Assemble

We drilled a small hole at our best guess as to where the center of the hole should be.

Using a plumb bob we measured how far off we were and made the correction.

Then we drilled out the holes.

Using a piece of welding wire we marked where the holes should be and drilled them.

The hole through the back wall has to be extra large to get the rear support to pass through. This will be covered by carpet later.