427 Cobra
Roll Bars
Change Order
Chronological Order
Main
Ordering
Receiving
Inventory
Fuel Tank
Brackets
Powder Coating
Engine Build
Frame Dolly
Frame Problems
Fuel Lines
Air Breather
Headers
Aligning The Body
Wheels
Clutch
Brake Lines
Pipes
Radiator
Roll Bars
Rear Axle
Body Mounting
Steering
Dash
Pedals
Engine Stand
Front Suspension
Engine Mount
Transmission Mount
Seats
Emergency Brake
Trunk Hinges
Trunk Latch
Trunk Lid Support
Door Latch
Door Striker
Door Fit
Hood
Hood Support
Rear Bumper
Gas Cap
Roll Bars Thru Body
Convertable Top
Wiring Trunk
Wiring Dash
Wiring
Wipers
Final Assemble

The roll bars would not fit together without some grinding.

After a lot of grinding, we were able to test fit them to the frame.  We found they would not line up with the brackets that were provided.

The rear brace did not line up with the shock tower where it is to be mounted.

If mounted to the shock tower with this misalignment, the brace would hit the body.

As you can see in this picture, there is a small gap between the shock tower and the body.

After cutting off the tube mount that StreetBeast had welded on, we were able to move the bars back to a better location.

The roll bars in place and holes marked for drilling.

Now with the roll bars being vertical, we can weld the tube mounts in place.

Now they line up.