427 Cobra
Frame Problems
Change Order
Chronological Order
Main
Ordering
Receiving
Inventory
Fuel Tank
Brackets
Powder Coating
Engine Build
Frame Dolly
Frame Problems
Fuel Lines
Air Breather
Headers
Aligning The Body
Wheels
Clutch
Brake Lines
Pipes
Radiator
Roll Bars
Rear Axle
Body Mounting
Steering
Dash
Pedals
Engine Stand
Front Suspension
Engine Mount
Transmission Mount
Seats
Emergency Brake
Trunk Hinges
Trunk Latch
Trunk Lid Support
Door Latch
Door Striker
Door Fit
Hood
Hood Support
Rear Bumper
Gas Cap
Roll Bars Thru Body
Convertable Top
Wiring Trunk
Wiring Dash
Wiring
Wipers
Final Assemble

Mounting the engine turned out to be a bigger job then we had expected.

StreetBeasts provided the "Frame Engine Mount Brackets".  If we mount them in the way that the manual said to do it, they would be at the wrong angle.  If we mounted them on the opposite side, they would be at the right angle, but it turned out they were too close, by about 1/2 inch.

So we are going too have to modify the brackets or build our own.

We also notice the rails that the radiator mounts on were not parallel.  So later in the project we will have to cut off one of the rails and weld on a new one.

So at this point we constructed a wooden frame to sit the engine on.

The rubber engine mounts seat on the top of this wooden frame.  By adjusting the wooden frame up and down, forward and rearward we can place the engine in the correct position.