427 Cobra
Engine Stand
Change Order
Chronological Order
Main
Ordering
Receiving
Inventory
Fuel Tank
Brackets
Powder Coating
Engine Build
Frame Dolly
Frame Problems
Fuel Lines
Air Breather
Headers
Aligning The Body
Wheels
Clutch
Brake Lines
Pipes
Radiator
Roll Bars
Rear Axle
Body Mounting
Steering
Dash
Pedals
Engine Stand
Front Suspension
Engine Mount
Transmission Mount
Seats
Emergency Brake
Trunk Hinges
Trunk Latch
Trunk Lid Support
Door Latch
Door Striker
Door Fit
Hood
Hood Support
Rear Bumper
Gas Cap
Roll Bars Thru Body
Convertable Top
Wiring Trunk
Wiring Dash
Wiring
Wipers
Final Assemble

I have decided to build a fully adjustable engine stand.  This will enable me to remount the engine and get it as close as possible to the scoop of the hood.

There are enough holes that will allow me to move the engine up or down 1/8 of an inch at a time.

Later I will move the engine into the frame area, place the body back on the frame and then adjust it up or down as needed.