427 Cobra
Convertable Top
Change Order
Chronological Order
Main
Ordering
Receiving
Inventory
Fuel Tank
Brackets
Powder Coating
Engine Build
Frame Dolly
Frame Problems
Fuel Lines
Air Breather
Headers
Aligning The Body
Wheels
Clutch
Brake Lines
Pipes
Radiator
Roll Bars
Rear Axle
Body Mounting
Steering
Dash
Pedals
Engine Stand
Front Suspension
Engine Mount
Transmission Mount
Seats
Emergency Brake
Trunk Hinges
Trunk Latch
Trunk Lid Support
Door Latch
Door Striker
Door Fit
Hood
Hood Support
Rear Bumper
Gas Cap
Roll Bars Thru Body
Convertable Top
Wiring Trunk
Wiring Dash
Wiring
Wipers
Final Assemble

As always the SB Manual was very little help.

We made a marked every 4 inches and installed the snaps.

We used a 17/64 hole punch I got from Tandy Leather.

We measured 7/8 inch from the edge and made a hole.

Next we placed the back plate of the snap over the hole and using a hobby knife made 4 cuts for the snap tangs to come through.

Here we are pushing the tangs through the cuts.

Here you can see the tangs coming through the back plate.

Here Clint is prebending the tang over a little.

He then finish bending the tang with a small hammer.

Next we'll work on the windshield.